Table of Contents
Advertisement
adjustments to allow the boat to respond. If you over trim, simply give the over trimmed tab an adjustment in the
opposite direction. Push the top half of both rocker switches in half-second increments to trim the bow down.
Warning: Trim tabs can cause a dramatic change in the attitude and heading of your boat.
Adjust them in small increments when in open water and clear of any obstructions.
Trim Tab Indicators (Optional)
This optional indicator switch may be added when trim tabs are factory installed standard
trim tab package. The waterproof indicator and switch lights up to let you know exactly
where your trim tabs are.
Windlass with Rode and Chain
The windlass anchor system is located on
the bow. It is an electric hands free anchor
system that allows the driver to raise or
lower the anchor while staying at the helm.
The windlass comes with 200 feet of ½
inch line and 6 feet of ¼ inch rode.
The windlass is operated by a separate
switch and is protected by a 50-amp
breaker. The switch is located at the helm.
The breaker is located on the console in
close proximity to the switch.
To operate the windlass, press the windlass toggle switch to the down position to release the anchor and line.
After dropping the anchor, be sure to tie the line off at one of the cleats. If you do not tie off at a cleat, the
constant pull against the line could cause the windlass motor to fail. To retrieve the anchor, press the windlass
switch to the up position and carefully raise the anchor up but not allowing it to hit the boat.
Refer to the owner's manual that was provided by the manufacturer of the windlass for operational procedures
and information related to the care and maintenance of their product. When in doubt, always defer to the
windlass manufacturer's instructions and/or recommendations.
Windlass Foot Switch (Optional)
The windlass foot switch requires the installation of the windlass with rode and
chain. This feature, which includes two (2) foot switches that are installed on
the bow of the boat next to the windlass, lets you raise or lower the anchor
simply by depressing either the up or down switch.
Refer to the owner's manual that was provided by the manufacturer of the
windlass foot switch for operational procedures and information related to the
care and maintenance of their product. When in doubt, always defer to the
component manufacturer's instructions and/or recommendations.
Bow Thruster (Optional)
When it comes to docking in tight spaces, a bow thruster can be a true godsend – but its benefits don't end there.
As a growing number of anglers are discovering, a bow thruster can also prove useful in many fishing situations.
The increased maneuverability is a great asset when working a fish. The performance of a single- or multi-engine
outboard can be enhanced when a thruster is installed, not only in terms of dockside maneuvering, but also when
fighting fish. The bow thruster package includes either a joystick control or a touch pad control.
Windlass
Windlass switch
13
Advertisement
Table of Contents
