Cabin / Companionway Door; Hardware; Cleats; Bow Rail - Pro-Line Boats 32 Express 2010 Owner's Manual

Cabin / Companionway Door

The acrylic cabin door is equipped with a locking latch, doorstop and a
slide mechanism. To open the door, just press the black latch on the
latch assembly to the right and slide the cabin door to the starboard side.
To close the door, slide the door back to the port side and the latch will
engage itself.
The stainless steel doorstop at the bottom of the doorframe can be
utilized to keep the door from sliding shut when you are underway or
anchored. When using the doorstop, take notice of the prevailing seas.
The door should never remain open when you are underway or when
conditions might cause a passenger to lose their balance and accidentally
fall through the doorway.
The lock comes with a set of two numbered keys. We recommend that
you make note of the key number and keep it in a safe place. In the
event that you need to replace the keys, this will allow you to replace just
Doorstop
the keys and not the entire lock assembly.
See the Service and Care section of this manual for cleaning recommendations.

Hardware

Cleats

Your boat is equipped with 2 pop-up and 5 standard cleats. They are installed to provide areas to permit you to
tie off the boat at dockside, tie off to another boat that is anchored, secure bumpers/fenders, and/or tie off the
anchor (when dropped) to prevent the line from pulling on the windlass, etc. You should never use the cleats for
towing another boat or skier.

Bow Rail

The bow rail is constructed of stainless steel. The railing, which is through bolted to the gunwale, is provided for
safety. Never use the bow rail to tie off to anything heavier than a bumper/fender. Do not use the bow rail for
anchoring, or to tie off to the dock or another boat. Do not use the bow rail to tow another boat or skier. Never
stand on the bow rail or use it as leverage when pulling up an anchor, a fish or any other objects. Do not use the
bow rail to tie off and/or secure a large catch, etc.

Grab Rails

A set of 4 stainless steel grab rails has been installed to provide safe boarding and navigation on the boat. They
are located at the port transom ladder, around the baitwell station, on the port side cabin wall as you step down
into the cabin and on the forward wall of the head.

Gunwale Trim / Rubrail

A white rigid vinyl gunwale trim with a stainless steel insert is installed at the juncture of the deck and hull. This
durable trim provides a nice clean look and serves as somewhat of a cushion when you are docking, coming
along side another vessel, etc.
See the Service and Care section of this manual for cleaning recommendations.

Thru Hull Fittings

Thru hull fittings provide overboard drainage. The following photos indicate the source of drainage for each of the
thru hulls.
40