Steering Wheel; Trim Tabs - Pro-Line Boats 32 Express 2010 Owner's Manual

switch in the up position and trim the engine to the full up position. Repeat the same process by pressing the trim
toggle switch down and the engine will go into the full down position. See the Trim and Tilt information in the
Operations section of this manual.

Steering Wheel

The stainless steel steering wheel is mounted at the helm along with the
binnacle, switch panel and other controls. Please refer to the Care and
Maintenance section of this manual for cleaning recommendations.

Trim Tabs

The trim tabs come equipped with auto retract. The planing tabs are located on each side of the transom on the
bottom of the hull. The trim tabs operate independently, up or down, to correct for differing conditions of wind or
load. Refer to the owner's packet for specific information.
Check the operations of your trim tabs before getting underway. To operate the trim tabs locate the trim tab
rocker switches on the console. Press both switches forward and hold them down. This will engage both trim
tabs and will ensure they are working properly while in the full down position.
The switch on the port side operates the starboard trim tab. The switch on the starboard side operates the port
trim tab. To check each trim tab individually, press one of the trim tab rocker switches to the forward position and
check to see if the opposite trim tab goes down. For example if the starboard trim tab switch is being pressed
down, the port trim tab should be going down. Repeat the same process for the opposite side.
While underway and in open water, clear of other boaters, depress the top half of the switches in half-second
increments to achieve the desired degree of trim. To correct a starboard list, depress the top half of the port
switch in small increments until the list is corrected. To avoid over trim, allow a few seconds between tab
12