Table of Contents
Advertisement
Shift / Throttle / Trim
Your Pro-Line can be ordered with different shift/throttle systems based upon motor type. Refer to the owner's
packet to find the manual pertaining to your particular installation. Each motor has an individual tilt/trim switch
located on the port throttle lever. Separate shift and throttle controls are available for each outboard motor.
The throttle lever has three range positions: "Forward", "Neutral", and "Reverse". The shift function occurs in the
first portion of the lever travel. After the transmission is shifted into gear, further movement of the lever advances
the throttle.
Push the throttle lever ahead to move forward and pull it back for reverse. Centralize the lever to the detent
position for neutral. The throttle lever is equipped with a neutral safety switch to prevent the motor from starting in
gear. The initial short movement of the lever to engage the transmission should be made firmly to avoid causing
gear clash.
CAUTION: Use care in shifting to avoid advancing the throttle more than intended.
Steering - Hydraulic with Tilt
Steering systems will differ depending upon your selection of engine package. Please carefully read the owner's
manual provided by the specific manufacturer. Tilt steering is included with all factory installed engine packages.
Hydraulic Steering (Verado – Power)
Your Pro-Line is equipped with a self-contained hydraulic steering system when your engine package is factory
installed. When the steering wheel is turned, the helm pump pumps fluid to the steering cylinder causing it to
extend or retract. Periodically, check the fluid level and fill as necessary. Beware of adding too much fluid,
especially if the ambient temperature is cold because subsequent expansion could cause leaking or damage to
your system. Refer to the owner's manual that was provided by your engine manufacturer.
After every 24 hours of operation check all nuts, caps, and hose fittings for tightness. Make sure the hoses are
not chafing or kinking on sharp corners. Also, check that hose ends are not damaged or distorted. The fluid
should be changed annually under normal conditions and every six months during times of heavy usage. If your
steering does not operate properly, check the following:
Drive entanglements
Level of the hydraulic steering fluid
To properly check the steering system, start by turning the steering wheel port to starboard. If the engine does
not respond the same time as the steering wheel is being turned, this means that there is air in the steering
system and the steering system needs re-bleeding. When there is air in the steering, the steering wheel will feel
"loose". Contact your dealer to have them bleed the steering system.
Steering – Power Assist (Optional – Standard with Verado Power)
Experience the automotive style comfort hydraulic steering can achieve
with power assist.
It's the perfect addition for boats equipped with
standard hydraulic steering. Power assist increases steering comfort
with reduced wheel effort. This system is available for 150HP+ single
outboards, heavy 4 stroke outboards and twin or triple outboards.
Power Trim
The power trim unit is located on the engine and can be operated by using the trim button on the engine or by
using the trim toggle switch on the binnacle. To ensure the power trim is working, start by pressing the toggle trim
Hoses and/or fittings for leaks
Air in the steering system
11
Advertisement
Table of Contents
