Table of Contents
Advertisement
To open the windshield vent, depress and hold the switch in the up or forward
position. Release the switch when the windshield vent reaches the desired
position. When you are ready to close the windshield vent, depress the switch
in the down position until the windshield vent has closed or reached the desired
position. Once the vent has traveled to the full out or full in position, you should
release the switch.
Windshield Wipers
Depressing the switch to the up or forward position activates the starboard wiper. Depressing the 3-position
switch to the down or aft position will activate both the port and starboard wipers. The center position on the
switch is the off position for both wipers. If at all possible you should try never to run the wipers on a dry
windshield. This will dramatically reduce the life of your wiper blades.
Windows
To allow for proper ventilation, 3 styles of windows have been installed throughout the cabin.
Mid Berth Cabin Window - A window is installed in the mid berth cabin and is
hinged at the top. To open the window, turn the 3 latches to the horizontal
position and lift the window open. To close the window, rotate the hinged
window back into the closed position and turn the 3 latches back to the vertical
position to secure the window.
Cabin Hatches - A pair of cabin hatches complete with screens is installed in
the ceiling of the main cabin. To open the window, remove the screen, turn
both levers forward and push the hatch open to the desired position. To hold
the hatch in place, tighten the black plastic cylinders on both of the mounting
arms. Then replace the screens. DO NOT allow passengers to sit or stand on
the hatches as they could break the hatches. The hatches should be in the
closed and latched position when the vessel is underway.
Cabin Portholes - Two portholes complete with screens are installed in
the main cabin. One is located in the galley and the other is located in
the head. To open the porthole window, loosen the 3 star nuts by turning
them in a counter clockwise direction. Then, rotate each of the star nuts
down (away from the plastic window); the window is hinged at the top.
Once the star nuts are out of the way, lift the window open and away from
the frame by carefully pulling on the phalanges at the bottom of the
window.
When finished, close the window, rotate each of the star nuts back into
place and turn the star nuts in a clockwise direction to secure the window.
Transom Door
The transom door is located on the starboard aft corner of the boat. The sliding
bolt style latch secures the door in the closed position. To open the door, slide the
latch starboard (to the left from inside the cockpit).
The transom door should always remain closed while underway. When the boat is
anchored, the transom door can be held open by the magnetic locking mechanism
mounted on the starboard aft freeboard. To close the door, pull the door firmly to
release the magnet and move the door to the closed position. To door latch will
engage automatically.
See the Service and Care section of this manual for cleaning recommendations.
3 Star Nuts
39
Advertisement
Table of Contents
