Table of Contents
Advertisement
The fresh water system hose is located just outside the transom door, behind a white
cap/cover. Pull open the cap and pull out the faucet/shower nozzle and hose. Press the
button on the nozzle to ensure proper operation (water spraying).
When you are finished, stow away the transom fresh water hose and cover the outlet with
the white rubber cap. If the fresh water system is not in going to be in use, return to the
switch panel and turn the fresh water switch to the off position. When you close the
faucet, the pump will run briefly. If the pump continues to run with the faucet closed,
check the system for leaks or have the pump tested.
Note: If you should hear a sucking sound, you may have a leak on the inlet side of the fresh
water tank. There are 2 hoses connected to the top of the tank. The larger diameter hose is the
water fill hose and the smaller diameter hose is the water vent hose. Inspect the hoses for leaks
and make certain that the hose connections are secure.
Fresh Water Cockpit Shower
The fresh water system hose is located just outside the transom door, behind a white
cap/cover. Pull open the cap and pull out the faucet/shower nozzle and hose. Press
the button on the nozzle to ensure proper operation (water spraying). Depress the fresh
water switch located on the switch panel to the forward position to activate the fresh
water pump. Then, press the button on the faucet/nozzle to begin spraying. See the
section titled Fresh Water Pump for operating instructions before using the fresh water
shower.
Cabin Sink
The cabin sink and countertop are made of the same gelcoat covered
fiberglass that is used in the construction of the deck and hull of the boat.
For information on keeping the sink and countertop looking like new, please
refer to the Gelcoat and Fiberglass areas in the Service and Care section of
this manual.
Any water poured into the cabin sink will gravity drain
overboard via the amidships thru hull.
Note: Do not place any hot materials on this Fiberglass
countertop as this surface could melt or burn.
For information on keeping the sink and countertop looking like new, please refer to the Gelcoat and Fiberglass
areas in the Service and Care section of this manual.
Stereo Equipment (Optional)
Please refer to the owner's manuals provided by the manufacturers of the stereo components listed in this section
for operational procedures and for information related to the care and maintenance of their products. When in
doubt, always defer to the component manufacturer's instructions and/or recommendations.
Note: The individual manufacturers of each of the following products listed in this section provide
the limited warranties for their equipment and most associated parts.
provides recommendations regarding service and warranty related issues.
service and/or warranty repairs must be performed by a repair facility that is authorized to work
on their equipment.
Based upon the availability from our vendors, this equipment changes from time to time. Therefore, we request
that you refer to the owner's manual provided by the manufacturer of the XM unit for operational procedures and
for information related to the care and maintenance of their product.
Each manufacturer
In many cases,
26
Advertisement
Table of Contents
