Stove; Flooring; Laminated Wood Grain Flooring; Teak And Holly - Pro-Line Boats 32 Express 2010 Owner's Manual

Stove

The outside of the stove can be wiped clean with a mild solution of dishwashing detergent and warm water. Avoid
abrasive cleaners or cleaning pads. Dry thoroughly before use.
Removable grate/drip pan is dishwasher safe. Use gentle scrubbing with a dry bristle brush when cleaning the
burner head. Make sure all gas openings are free of obstructions.

Flooring

Laminated Wood Grain Flooring

Pick up loose dirt with a vacuum cleaner or Dust Buster and wipe up spilled materials with a clean damp cloth.
For normal cleaning, use only a mild dishwashing soap (i.e., Dawn, Ivory, etc.), warm water and a soft cloth. For
stubborn stains, please refer to the material in your Owner's Package that was provided by the manufacturer of
the laminated flooring.

Teak and Holly

The optional Teak and Holly flooring is covered with a lacquer finish. Pick up loose dirt with a vacuum cleaner or
Dust Buster and wipe up spilled materials with a clean damp cloth. For stubborn stains, you may use household
products such as Old English Furniture Polish, Liquid Gold, Pledge, Endust, etc.
commercially available at most grocery stores, Home Depot, Lowes, etc.

Winterizing and Storage

Your new Pro-Line was winterized before it left the factory. If you launch the boat prior to storing it for the winter,
please complete and/or comply with the following check list in order to ensure an easy "fitting out" in the spring:
Pre-Storage Check List:

Remove drain plugs, keeping the bow high to drain any water accumulation.

Run a pint of RV antifreeze through the bilge pump.

Drain all water systems, including the head, and pump an approved antifreeze through all pumps,
valves, drains and lines.

Fill fuel tank (3/4 – 7/8 full) and add a stabilizer/conditioner such as "STA-BIL" to the gasoline.

Prepare engine in accordance with the engine manufacturer's recommendations found in your
engine manual.

Treat metal parts with a rust inhibiter.

To prevent mold and mildew, use an absorbing product such as DampRid according to the
manufacturer's directions.
charcoal briquettes that have not been pre-treated with lighter fluid.

Remove batteries and protect them from freezing. Trickle charge overnight once a month.

Place under cover. If the boat is stored on a trailer, loosen tie-down straps and place blocks
beneath axles to relieve the load on the tires.
For inboard/outboard engines only, to protect your boat during transport, the following procedures were affected
at the factory prior to shipping and will need to be rectified prior to launch:

Drain plugs on engine block removed.

Petcocks on engine removed.

Large hose on re-circulating pump removed.

Power steering cooler hose removed.

All other water hoses disconnected (left in place with hose clamps tightened to prevent their loss).
Fitting Out After Storage

Check entire fuel system for loose fittings, leaks and damage.

Clean battery terminals; install battery(s), and coat terminals with a deoxidizing agent.
An alternative and inexpensive option is to fill egg cartons with
These products are all
62