Multi Sv - Autonics TK4S User Manual

6.7.2.2 Stop Alarm Output [PAR5 → ST.AL]
Enable or disable alarm output upon a stop.
Setting
Group
PAR1
6.7.3

Multi SV



6.7.3.1 Number of Multi SVs [PAR5 → MT.SV]
This parameter sets the number of Multi SVs. Select the number of Multi SVs required by
the control subject.
Setting
Group
PAR5
© Copyright Reserved Autonics Co., Ltd.
Ignores MV from ON/OFF control or PID control and sends out a control
value based on the defined MV.
Setting
Alarm output ceases along with a stop under all conditions.
(However, reverting to Run mode after a stop in alarm latch or alarm
OFF
latch and standby sequence restores the alarm output to the
previous state.)
Alarm output continues regardless of control operation.
CONT
Parameter
R-S
Multi SV function allows users to set multiple SVs and save each setting in SV0 to
SV3. Users can change SV-N or select desired SV using external DI (Digital Input, DI-
1, DI-2) terminals.
This feature supports up to four SVs which can be independently configurable.
Number of SVs
SV-0
1 EA
SV-0, SV-1
2 EA
SV-0, SV-1, SV-2, SV-3,
4 EA
Parameter
MT.SV
If the Digital Input (, ) feature has been set for multi SV (MT.SV),
the number of Multi SV(MT.SV) is not modified through pressing key or
communication.
6 Parameter Settings and Functions
Description
Setting Range
CONT / OFF
SV Assignment
Setting Range
1 / 2 / 4
Factory
Unit
Default
-
CONT
Factory
Unit
Default
EA
1
99