Basic Controls; Parameter Setting Sequence; Sv Settings - Autonics TK4S User Manual

5.3

Basic Controls

5.3.1

Parameter Setting Sequence

Parameter 3 Setting Group [PAR3] → Parameter 4 Setting Group [PAR4] → Parameter 5
Setting Group [PAR5] → Parameter 2 Setting Group [PAR2] → Parameter 1 Setting Group
[PAR1] → SV Setting Group [SV]
5.3.2

SV Settings

Flow chart for SV setting is as follows:
1
2
3
© Copyright Reserved Autonics Co., Ltd.
Parameters from different setting groups are linked to one another;

therefore, initial parameterization should be performed in the above
sequence.
Changing Parameter 3 Setting Group's parameters can sometimes

reset other associated parameters. Always make sure to check if
such parameters have been affected.
While in Run mode, press any ◀, ▼, or ▲.
Select the desired digit using the ◀ key.
Configure the desired numeric value using the ▼/▲ keys.
5 Preparation and Startup
35