Preparation And Startup; Powering On And Initial Display; Input Selection Switch - Autonics TK4S User Manual

5 Preparation and Startup

5 Preparation and Startup
5.1

Powering On and Initial Display

When powered on and providing no error is present, the unit's front display will turn on for
about a second and then twice display the model name, option/main outputs, and input
type in sequence at 0.5-second intervals.
SV Display
1,,2,,R,,T,,A,,B
4
R, S, C
N, R, C
5.2

Input Selection Switch



34
Display Category
Option Output,
Power
OUT1 Control Output
OUT2 Control Output
Before setting the temperature controller's internal parameters, position the input
selection switch located at the underside of the unit to the desired input specification.
Changing the input selection switch position resets temperature sensor input to KCaH
and results in display of thermocouple/RTD Input Types only. In the case of analog
input, it is reset to AV1, resulting in display of analog voltage/current Input types only.
Information
ALARM1/2, PV Transmission, RS485 Output
100 to 240 VAC, 50/60 Hz
Relay Contact, SSRP Output, Current + SSR
Output
None, Relay Contact, Current + SSR Output
© Copyright Reserved Autonics Co., Ltd.