Matrix Fitness PCTV Service Manual page 31

3.5 PCtV BRACKEt INStALLAtIoN & CoNSoLE SEtUP - t3x LMM CoNSoLE - CoNtINUEd
NOTE: The PCTV is a touch screen unit, and therefore will not work with the entertainment keypad. Leave the Standard Overlay on
(Figure E).
6) Feed the coax cable and TV power wire (4 pins - both wires come up the console mast), and controller signal wire (8 pins - from the console)
through the hole in the handlebar frame below the console (Figure F).
7) Remove the 4 screws holding the upper handlebar assembly to the console masts (Figure G).
8) Mount the TV bracket to the frame using the 4 screws removed in Step 7 (Figures H and I).
9) Connect the coax cable that was fed through the hole in the handlebar frame in Step 6 to the cable coming out of the TV bracket using the
coax adaptor sent with the bracket kit (Figure J).
10) Re-install the console onto the handlebar frame.
30
BRACKEt INStALLAtIoN & CoNSoLE SEtUP
FIGURE E
FIGURE G
FIGURE I
FIGURE F
FIGURE H
FIGURE J