Matrix Fitness PCTV Service Manual page 38

BRACKEt INStALLAtIoN & CoNSoLE SEtUP
3.6 PCtV BRACKEt INStALLAtIoN & CoNSoLE SEtUP - t3x LAM CoNSoLE - CoNtINUEd
18) Mount the TV to the bracket using 4 screws sent with the TV (Figure S).
19) Make sure that the tabs on the front plate are tucked behind the console faceplate to create a seamless look (Figure T).
FIGURE S
20) Install the console back cover removed in Step 2 (Figure U). NOTE: Make sure that the coax, power, net, and controller wires are tucked
in the slot in the cover (created by removing the small Matrix logo cover) (Figure V).
FIGURE U
21) Install the TV back cover onto the TV (Figure W).
22) Plug a working coax cable with a signal strength of 10 Hz to the port at the base of the treadmill (Figure X).
FIGURE W
FIGURE t
FIGURE V
FIGURE X
37