Chapter 3: Bracket Installation & Console Setup; Pctv Bracket Installation & Console Setup - 5X Tm Lmm Console; Assembly Instructions - Matrix Fitness PCTV Service Manual

3.1 PCtV BRACKEt INStALLAtIoN & CoNSoLE SEtUP - 5x tM LMM CoNSoLE
All T5x consoles have a minimum software version to allow a PCTV. See the minimum software version for this console in the table in Section
3.8. Check the software versions in Manager Mode. To enter Manager Mode press and hold ELEVATION and SPEED DOWN at the same time
for 3-5 seconds. Use the LEVEL keys to scroll to Manager Mode, and press ENTER. Then use the LEVEL keys to toggle to Software and hit
ENTER. This will display the current software versions. Use the LEVEL keys to toggle through the versions to find the UCB software version.
Press and hold the PAUSE key to exit.
Remove the power cord from the wall outlet prior to completing the steps below. For the installation of the PCTV, a bracket kit has been provided
containing various parts. Please note that not all parts will be used for this installation, as this kit is also used for other Matrix Fitness
products. Refer to the step-by-step instructions to determine which parts will be needed and which parts can be discarded.
To ensure correct assembly of the treadmill TV bracket, carefully read and follow these steps:
The PCTV must be tested for function after installation as some programming may be needed. NOTE: The PCTV is a touch screen unit,
and therefore will not work with the entertainment keypad. Leave the Target Heart Rate Overlay on the console.
NOTE: There is more than one version of the T5x console, please make sure the correct instructions for the console are being used.
1) Assemble the treadmill as outlined in the Assembly Instructions. Make sure that the coax cable is free and not wrapped around anything
(Figure A). NOTE: The PCTV is a touch screen unit, and therefore will not work with the entertainment keypad. Leave the Target Heart
Rate Overlay on the console (Figure B).
2) Remove the Matrix Fitness Logo from the console back and throw away. (Figure C)
3) Remove the back of the console and install the TV Mounting Bracket using the 4 screws and washers from the bracket kit. (Figure D)
12
BRACKEt INStALLAtIoN & CoNSoLE SEtUP

ASSEMBLY INStRUCtIoNS

FIGURE A
FIGURE C
ATTENTION:
FIGURE B
FIGURE d