Matrix Fitness PCTV Service Manual page 20

BRACKEt INStALLAtIoN & CoNSoLE SEtUP
3.2 PCtV BRACKEt INStALLAtIoN & CoNSoLE SEtUP - 5x tM LAM CoNSoLE - CoNtINUEd
16) Install the TV back cover using 4 screws (Figure S).
17) Plug the PCTV power wire into the port on the front of the treadmill near the power switch (Figure T).
FIGURE S
18) Plug a coax cable with a signal strength of 10 Hz into the front of the treadmill near the power cord (Figure U).
19) if using wired internet, plug a net wire into the port on the front of the treadmill near the power switch (Figure V).
FIGURE U
20) Enter into Engineering Mode by pressing INCLINE DOWN and SPEED DOWN keys at the same time and toggling to Engineering, then
press ENTER.
21) Toggle to Audio Source, then press ENTER. Toggle to PCTV and push ENTER. This will ensure the audio from the PCTV can be heard
through the treadmill headphone jack.
22) If the sound is too quiet or too loud, toggle to Volume Control, and push ENTER. When the screen says Output Default push ENTER again.
The volume range can be adjusted.
23) Press and hold the PAUSE or STOP key for 3 - 5 Seconds or press the EMERGENCY STOP to return to normal operation.
24) A channel scan should be done using the instructions included in the TV owner's manual.
FIGURE t
FIGURE V
19