Matrix Fitness PCTV Service Manual page 39

BRACKEt INStALLAtIoN & CoNSoLE SEtUP
3.6 PCtV BRACKEt INStALLAtIoN & CoNSoLE SEtUP - t3x LAM CoNSoLE - CoNtINUEd
23) Plug the TV power wire into the port at the base of the treadmill (Figure Y).
24) Plug a network cable into the port at the base of the treadmill if using wired internet (Figure Z).
FIGURE Y FIGURE Z
25) Enter Engineering Mode by pressing the INCLINE DOWN and SPEED DOWN keys at the same time and toggling to Engineering, then press
ENTER.
26) Toggle to Audio Source and push ENTER. Toggle to PCTV and push ENTER. This will ensure the audio from the PCTV can be heard through
the treadmill headphone jack.
27) If the sound is too quiet or too loud, toggle to Volume Control, and push ENTER. When the screen says Output Default push ENTER again.
The volume range can be adjusted.
28) Press and hold the PAUSE or STOP key for 3 - 5 Seconds or press the EMERGENCY STOP to return to normal operation.
29) A channel scan should be done using the instructions included in the TV owner's manual.
38