Matrix Fitness PCTV Service Manual page 25

3.3 PCtV BRACKEt INStALLAtIoN & CoNSoLE SEtUP - 5x UNIVERSAL LMM CoNSoLE - CoNtINUEd
19) Use the double sided tape to secure the dongle to the PCTV plastics (Figure V). If the system is wired, skip this step.
20) Plug the TV power wire coming up the console mast into the TV power wire installed in step 15. Both wires are labeled "TV".
21) Reinstall the console.
22) Plug the side of the controller wire labeled TO CONSOLE into the C-Safe port on the back of the console (Figure W). NotE: The TV port is
next to the C-Safe port and will not work for PCTV.
23) Install the PCTV back cover (Figure X).
24) If the PCTV is going to be connected to the internet through an Ethernet Cable, plug the Ethernet cable into the Ethernet port on the bottom
of the treadmill (Figure Y).
25) Plug in the PCTV power wire into the base of the cardio (Figure Y)
26) Enter Engineering Mode by pressing the INCLINE DOWN and SPEED DOWN keys at the same time and toggling to Engineering, then press
ENTER.
27) Toggle to Audio Source and push ENTER. Toggle to PCTV and push ENTER. This will ensure the audio from the PCTV can be heard through
the treadmill headphone jack.
28) If the sound is too quiet or too loud, toggle to Volume Control, and push ENTER. When the screen says Output Default push ENTER again.
The volume range can be adjusted.
29) Press and hold the PAUSE or STOP key for 3 - 5 Seconds to return to normal operation.
30) A channel scan should be done using the instructions included in the TV owner's manual.
24
BRACKEt INStALLAtIoN & CoNSoLE SEtUP
FIGURE V
FIGURE X
X
FIGURE W
FIGURE Y