Pctv Bracket Installation & Console Setup - Universal 3X Console - Matrix Fitness PCTV Service Manual

BRACKEt INStALLAtIoN & CoNSoLE SEtUP
3.7 PCtV BRACKEt INStALLAtIoN & CoNSoLE SEtUP - UNIVERSAL 3x CoNSoLE
All Universal 3x consoles have a minimum software version to allow a PCTV. See the minimum software version for this console in the table in
Section 3.8. The software versions can be found in Manager Mode. To enter Manager Mode press and hold LEVEL UP and DOWN at the same
time for 3-5 seconds. Use the LEVEL keys to scroll to Manager Mode, and press ENTER. Then use the LEVEL keys to toggle to Software and
hit ENTER. This will display the current software versions. Use the LEVEL keys to toggle through the versions to find the UCB software version.
Press and hold the PAUSE key to exit.
Please make sure that the power cord is not plugged into the wall outlet while completing the following procedure. For the installation of the
PCTV, a bracket kit has been provided containing various parts. Please note that not all parts will be used for this installation, as this kit is
also used for other Matrix Fitness products. Refer to the step-by-step instructions to determine which parts will be needed and which parts
can be discarded. To ensure correct assembly of the treadmill TV bracket, carefully read and follow these steps:
The PCTV must be tested for function after installation as some programming may be needed. If the channels come in only black and
white, or if only some channels are received, reference the troubleshooting guide at the back of this manual, or contact Matrix Fitness
at 866.693.4863. The PCTV is a touch screen unit, and therefore will not work with the entertainment keypad. Install the Target Heart
Rate Overlay.
1) Turn off power and disconnect the power cord.
2) Remove the console from the unit.
3) Remove the 2 screws holding the small silver back cover to the console and remove the back cover (Figures A & B).
FIGURE A
4) Remove the 4 screws holding the rear half of the console to the front half and split the console (Figures C & D).
FIGURE C
ASSEMBLY INSTRUCTIONS
ATTENTION:
FIGURE B
FIGURE d
39