Matrix Fitness PCTV Service Manual page 44

BRACKEt INStALLAtIoN & CoNSoLE SEtUP
3.7 PCtV BRACKEt INStALLAtIoN & CoNSoLE SEtUP - UNIVERSAL 3x CoNSoLE - CoNtINUEd
21) Run the coax cable from the top of the console to the back of the PCTV and screw it in (Figure W).
22) Install the PCTV back cover (Figure X).
FIGURE W
23) If the PCTV is going to be connected to the internet through an Ethernet cable, plug the Ethernet cable into the yellow Ethernet port on the
bottom of the unit (Figure Y). If the PCTV is wireless, skip this step.
24) Install the external TV power cord and screw it in (Figure Y).
25) Install the coax cable at the base of the unit (Figure Y).
26) Enter Engineering Mode by pressing the LEVEL UP and LEVEL DOWN keys at the same time and toggling to Engineering, then press EN-
TER.
27) Toggle to Audio Source and push ENTER. Toggle to PCTV and push ENTER. This will ensure the audio from the PCTV can be heard through
the treadmill headphone jack.
28) If the sound is too quiet or too loud, toggle to Volume Control, and push ENTER. When the screen says Output Default push ENTER again.
The volume range can be adjusted.
29) Press and hold the PAUSE or STOP key for 3 - 5 Seconds to return to normal operation.
30) A channel scan should be done using the instructions included in the TV owner's manual.
FIGURE Y
FIGURE X
43