Matrix Fitness PCTV Service Manual page 16

BRACKEt INStALLAtIoN & CoNSoLE SEtUP
3.1 PCtV BRACKEt INStALLAtIoN & CoNSoLE SEtUP - 5x tM LMM CoNSoLE - CoNtINUEd
14) If the PCTV is going to be connected to the internet through an Ethernet cable, plug the Ethernet cable into the yellow Ethernet port on the
bottom of the treadmill (Figure P). If the PCTV is wireless, skip this step.
15) Plug the TV power brick into the bottom of the treadmill (Figure P).
16) Plug a coax cable with a signal strength of 10 Hz into the bottom of the treadmill (Figure P).
17) Install the console and PCTV back covers (Figure Q). NOTE: Be sure to route the cables to the TV through the hole in the console back
cover created by removing the Matrix Fitness logo plate (Figure R).
FIGURE Q
18) Enter Engineering Mode by pressing the INCLINE DOWN and SPEED DOWN keys at the same time and toggling to Engineering and press
ENTER.
19) Toggle to Audio Source and push ENTER. Toggle to PCTV and push ENTER. This will ensure the audio from the PCTV can be heard through
the treadmill headphone jack.
20) If the sound is too quiet or too loud, toggle to Volume Control, and push ENTER. When the screen says Output Default push ENTER again.
The volume range can be adjusted.
21) Press and hold the PAUSE or STOP key for 3 - 5 Seconds or press the EMERGENCY STOP to return to normal operation.
22) A channel scan should be done using the instructions included in the TV owner's manual.
FIGURE P
FIGURE R
15