Matrix Fitness PCTV Service Manual page 27

BRACKEt INStALLAtIoN & CoNSoLE SEtUP
3.4 PCtV BRACKEt INStALLAtIoN & CoNSoLE SEtUP - 5x UNIVERSAL LAM CoNSoLE - CoNtINUEd
6) Run the white end from the Y cable through the headphone jack hole in the console plastic, and plug it into the headphone jack sent with the
TV bracket set (Figure G).
7) Mount the headphone jack into the console plastic using the 2 screws removed in Step 3 (Figure H).
FIGURE G FIGURE H
8) Mount the TV bracket to the console using 4 socket head screws sent with the TV bracket kit (Figure I).
9) Plug the 4 pin black connector to the power wire coming up the console mast from the base of the unit (Figure J).
FIGURE I FIGURE J
10) Plug the side of the controller wire labeled To Console into the CSafe board mounted on the console back (Figure K). The wire goes into
the PCTV port. Also change switch SW1 to the top location for PCTV.
11) Route the net and power cables through the console. These wires are not plugged into the UCB, but should be routed through the console
to hide the wires. The 8 & 4 pin black connectors shouild stick out the bottom of the console along with the HR wiring (Figure L).
12) Connect one end of the coax cable to the board on the back cover using the adaptor sent with the TV kit (Figure M).
FIGURE K FIGURE L FIGURE M
26