Matrix Fitness PCTV Service Manual page 23

3.3 PCtV BRACKEt INStALLAtIoN & CoNSoLE SEtUP - 5x UNIVERSAL LMM CoNSoLE - CoNtINUEd
9) Connect the net wire and coax cable from the TV to the ones coming up the console mast (the coax connection will use an adaptor from the
bracket kit) and push the TV power wire into the console mast so that it is accessible (Figure K).
10) Connect the TV bracket to the console mast using the 4 screws that were holding the logo in place in Step 7 (Figure L).
11) Insert the spring pin into the hole at the top of the TV bracket (Figure M).
12) Install the rabbit ears onto the TV bracket using the bolt, nut, and washers from the TV bracket kit (Figure N). NOTE: Make sure that the
rabbit ears are installed so that the spring pin is restricting the range of motion (Figure O).
22
BRACKEt INStALLAtIoN & CoNSoLE SEtUP
FIGURE K
FIGURE N
FIGURE M
FIGURE L
FIGURE o