Pctv Bracket Installation & Console Setup - 5X Universal Lmm Console - Matrix Fitness PCTV Service Manual

3.3 PCtV BRACKEt INStALLAtIoN & CoNSoLE SEtUP - 5x UNIVERSAL LMM CoNSoLE
All Universal 5x consoles have a minimum software version to allow a PCTV. See the minimum software version for this console in the table in
Section 3.8. The software versions can be found in Manager Mode. To enter Manager Mode press and hold ELEVATION and SPEED DOWN
at the same time for 3-5 seconds. Use the LEVEL keys to scroll to Manager Mode, and press ENTER. Then use the LEVEL keys to toggle to
Software and hit ENTER. This will display the current software versions. Use the LEVEL keys to toggle through the versions to find the UCB
software version. Press and hold the PAUSE key to exit.
Please make sure that the power cord is not plugged into the wall outlet while completing the following procedure. For the installation of the
PCTV, a bracket kit containing various parts has been provided. Please note that not all parts will be used for this installation, as this kit is
also used for other Matrix Fitness products. Refer to the step-by-step instructions to determine which parts will be needed and which parts
can be discarded. To ensure correct assembly of the treadmill TV bracket, carefully read and follow these steps:
The PCTV must be tested for function after installation as some programming may be needed. If the channels come in only black and
white, or if only some channels are received, reference the troubleshooting guide at the back of this manual, or contact Matrix Fitness
at 866.693.4863. The PCTV is a touch screen unit, and therefore will not work with the entertainment keypad. Leave the Target Heart
Rate Overlay.
NOTE: There is more than one version of the Universal 5x console, please make sure the correct instructions for the console are being
used.
1) Turn off power and disconnect the power cord.
2) Remove the console from the unit.
3) Remove the 6 screws holding the 2 halves of the console together and split the console (Figures A & B).
4) Assemble the new head phone jack and wire (Figure C).
5) Remove the existing blank head phone jack cover. NOTE: The PCTV is a touch screen unit, and therefore will not work with the
entertainment keypad. Leave the Target Heart Rate Overlay on the console. (Figure D)
20
BRACKEt INStALLAtIoN & CoNSoLE SEtUP
ASSEMBLY INStRUCtIoNS
FIGURE A
FIGURE C
ATTENTION:
FIGURE B
FIGURE d