Restrictions On The Use Of Lan2 (Pcs-Xg80/Xg80S/Xa80 Only) - Sony PCS-XG80 Operating Instructions Manual

Restrictions on the
Use of LAN2
(PCS-XG80/XG80S/
XA80 only)
When you use two LAN connections, use
the 1 (LAN1) connector to connect a
private network in your company and the
2 (LAN2) connector to connect to an
intranet outside your company.
The following functions of the system are
restricted when using the
connector.
Notes
• In the event of using the
connector to connect to an intranet outside
your company, make sure to set "Web
Access", "Telnet Access" and "SSH Access"
to "Disabled" on the Access Permit page of
the Administrator setup menu (page 98).
• The 2 (LAN2) connector cannot be used
on its own.
Items that cannot be set with LAN2
• NAT Mode
• Gatekeeper
• SNMP Mode
• SIP
• NTP
• Shared Phone Book
• AMX Device Discovery
• H.460
• DNS
• Streaming
• IPv6
• Web Access, Telnet Access, SSH Access
Item that can be set with either
LAN1 or LAN2
• PPPoE
Items to be set with LAN1 or LAN2
individually
• DHCP Mode
• IP Address
2 (LAN2)
1 (LAN1)

Restrictions on the Use of LAN2 (PCS-XG80/XG80S/XA80 only)

• Network Mask
• Gateway Address
• LAN Mode
Items to be set with LAN1 and LAN2
commonly
• Used Port Number (TCP, UDP)
• QoS
• TOS
• Auto Answer
• Reject Answer
Note
Do not set the same subnet for the LAN1 and
LAN2 connections.
107