Video Setup Menu - Sony PCS-XG80 Operating Instructions Manual

REC OUT Mode
Stereo: The mixed sounds of the remote and
local sites are output from the REC OUT
R and L jacks in stereo.
Monaural 2ch: The sounds of the remote
and local sites are output from the REC
OUT R and L jacks separately.
Lens Cover Mic On/Off Function
Select whether the mic turns on or off based
on whether the lens cover is open or closed.
On: When the lens cover is closed, the mic
turns off.
Off: Opening and closing of the lens cover
does not affect the mic.
Note
This setting is available only on the PCS-
XA80/XA55.
Audio3
Sound Effect
Beep Sound
Allows you to select the volume of the beep
that sounds each time you press a button on
the Remote Commander from among
"Loud", "Medium" and "Quiet". You can
also select "Off" for the beep not to sound.
Sound Effect
Allows you to select the volume of output
sound when the system starts, or when
connection starts or is disconnected from
among "Loud", "Medium" and "Quiet".
You can also select "Off" for the sound not
to be output.
Dial Tone
Allows you to select the volume of a ring-
back and busy tones when you are dialing
from among "Loud", "Medium" and
"Quiet". You can also select "Off" for the
ring-back and busy tones not to be output.
Ringer Tone
Allows you to select the volume of a ring
tone when you receive a call from among
"Loud", "Medium" and "Quiet". You can
also select "Off" for the ring tone not to be
output.
80
Registering Local Information

Video Setup Menu

The Video setup menu is used to set up video
input/output.
Video1
Basic Setup
Video Input
Allows you to select the video input.
Camera: Selects the camera picture from
the camera connected to the CAMERA
connector.
RGB: Selects the video signal from the
external equipment connected to the
RGB IN connector.
YPbPr: Selects the video signal from the
external equipment connected to the
VIDEO IN YPbPr connector.
S-VIDEO: Selects the video signal from the
external equipment connected to the S
VIDEO IN connector.
Note
The "S-VIDEO" setting is not available on the
PCS-XG55/XG55S/XA55.
Presentation Screen
Allows you to select the display pattern of
the presentation screen.
The "Presentation Screen" settings are
enabled when the PCSA-DSG80 HD Data
Solution Software (not supplied) is installed,
and "H.239" is disabled during the
communication.
Full Screen: Sends the computer picture,
etc. from the external equipment
connected to the RGB IN connector in
full screen mode.
PandP: Sends the computer picture, etc.
from the external equipment connected
to the RGB IN connector and the
selected input picture such as a camera
picture in PandP mode.
Side by Side: Sends the computer picture,
etc. from the external equipment
connected to the RGB IN connector and
the selected input picture such as a
camera picture in Side by Side mode.