System Confi Guration Using Two Ip Connections (Pcs-Xg80/Xg80S Only) - Sony Ipela PCS-XG55 Integration Manual

1-2-4. System Confi guration Using Two IP Connections (PCS-XG80/XG80S only)
Set "Line I/F → Use LAN2" of the setting menu to "On".
This allows you to:
Connect your system to two networks using the
For example, you can use the
2 connector to connect to the Internet outside your company. There is no need to change the connec-
tion and settings in each case. After installing the PCSA-MCG80 HD MCU Software, you can hold a
multipoint conference which has a connection between your company's private network and the Internet
outside your company. Refer to "2-4. Important information about installation and setting of connection
using IP line of two networks (PCS-XG80/XG80S only)".
m . Only PCS-XG80/XG80S is available.
. If your system is connected with the
tem, such as the SIP server connection, gatekeeper connection, Telnet access, and Web
access, will not be available.
. If your system is connected to a single network connector, use the
use the
port does not operate.)
/
Setting restriction of each LAN (PCS-XG80/XG80S only)
Setting restriction of each LAN port
Items to be setup at each port
Items to be setup at either port
Items to be set up only at
(Items ineffective for LAN2 by
setting)
Items that are effective for both LAN1
and LAN2 by setting one
PCS-XG80
1 (LAN1) and
1 connector to connect to a private network in your company and the
2 connector with the system connected to a single network connector, the LAN
/
POWER/STANDBY
1
2
DHCP mode
IP Address, Network Mask, Gateway Address
LAN mode
PPPoE
WEB, TELNET, SSH
DNS Server
NAT, H.460
Gatekeeper
LAN1 SIP Server
SNMP Trap Destination
NTP
Shared Phone Book
AMX Device Discovery
Multicast Streaming
IPv6
Port Numbers (TCP/UDP)
QoS
TOS
Auto Answer
Reject Answer
2 (LAN2) connectors.
2 connector, some of the functions of your sys-
POWER/STANDBY
Inside company
Outside company
Internet
POWER/STANDBY
/
1 connector. (If you
1-29