Using A Second Camera - Sony PCS-XG80 Operating Instructions Manual

Using a Second Camera

You can connect the second camera through the PCSA-CXG80 Camera Unit.
Connection example for a second camera
First camera (PCSA-CXG80)
VISCA OUT
/
VIDEO IN AUDIO 2 IN
Y Pb Pr L
to VIDEO IN
YPbPr
Connect the video output connector on the second camera to the VIDEO IN
YPbPr jacks on the front of the Communication System or the S VIDEO IN or
RGB IN connector at the rear.
Note
The S VIDEO IN connector is not available on the PCS-XG55/XG55S.
Select "YPbPr", "S-VIDEO" or "RGB" in "Second Camera Input" of the
Camera setup menu depending on the connector to which the camera is
connected.
Notes
• The "S-VIDEO" setting is not available on the PCS-XG55/XG55S.
• The PCS-XA80/XA55 does not support the use of a second camera.
To switch the picture shot by two cameras
When you open the Camera menu, the instruction "F2: Switches to the first
camera." or "F2: Switches to the second camera." is displayed at the bottom of
the monitor screen. Each press of the F2 button on the Remote Commander
changes the picture shot by each camera.
For the procedure how to open the Camera menu, see "Adjusting the Camera"
on page 146.
VISCA cable
(not supplied)
to VISCA OUT
TERMINAL
OPEN
R MAINTENANCE
Video cable (not supplied)
Second camera
to VISCA IN
Using a Second Camera
to Video
output
(YPbPr)
183