Annotation Setup Menu; Camera Setup Menu; General Setup Menu - Sony PCS-XG80 Operating Instructions Manual

Enter the different SPID numbers in
the A1 and A2 text boxes.
For the AT&T 5ESS (Point-to-Point
Custom ISDN) switch type
You do not need to set up the SPID,
then no entry in the A1 and A2 (B1
and B2, C1 and C2, depending on the
number of lines you use) is required.
5
After the settings are completed,
select "Save", then press the ENTER
button.

Annotation Setup Menu

The Annotation setup menu is used for the
annotation function allowing you to write
letters or graphics on the screen using a pen
tablet.
Annotation
Annotation
Enable
Allows you to select whether the annotation
function is enabled.
On: Enables the annotation function.
Off: Disables the annotation function.
Color
Allows you to select the color of the letters
or graphics written on the screen with a pen
tablet.
You can select from among "Black", "Red",
"Blue", "Green", "Yellow", "Orange",
"Purple" and "White".
Line Density
Allows you to select the density of the line
written on the screen with a pen tablet.
You can select from among "Thick",
"Medium" and "Thin".

Camera Setup Menu

Camera
Camera
Fade In
Allows you to select whether to use the fade-
in function when the camera moves to the
preset position. The picture in the preset
position fades in on a monitor screen.
On: Enables the fade-in function.
Off: Disables the fade-in function.
Note
The Fade In function is not available on the
PCS-XA80/XA55 system.
Second Camera Input
Allows you to select the input connector on
the Communication System to which the
second camera is connected.
Note
The PCS-XA80/XA55 does not support the use
of a second camera.
RGB: Connects the second camera to the
RGB IN connector.
YPbPr: Connects the second camera to the
VIDEO IN YPbPr jacks.
S-VIDEO: Connects the second camera to
the S VIDEO IN connector.
Note
The "S-VIDEO" setting is not available on the
PCS-XG55/XG55S/XA55.

General Setup Menu

General1
Device Setup
Terminal Name
Input the local terminal name transmitted to
a remote party (up to 30 characters).
Standby Mode
Allows you to select whether the
Communication System enters standby
mode if it is idle for a specified period of
time.
Registering Local Information
91