Duplex Mode - Kyocera Mita FS-1800/N User Manual

Using the Operator Panel
?
ENTER
ENTER
MENU
2
Press the or
appears.
Paper Handling >
3
Press the > key.
4
Press the or
>Duplex Mode
None
5
Press the ENTER key. A blinking question mark (?) appears.
>Duplex Mode
? None
6
Press the or
display changes as shown below.
None (default)
Short edge bind
Long edge bind
7
When the desired duplex mode displayed, press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
Duplex Printing from the MP tray
In first mode, be sure to set the MP tray to the same paper size and paper
type as set for the current paper cassette. If the paper size or type differs, a
paper jam may result. Also note that it is not possible to select the MP tray
as the current paper cassette and perform duplex printing. We therefore
recommend that duplex printing be performed from the paper cassette.
1-102
key repeatedly until Paper Handling >
key repeatedly until >Duplex Mode > appears.
>
>
key to display the desired duplex mode. The