Understanding The Operator Panel - Kyocera Mita FS-1800/N User Manual

Understanding the Operator Panel

1.1 Understanding the Operator Panel
The operator panel has a LCD message display, indicators, and eight keys.
Message Display
The message display gives information in the form of short messages. The
eight messages listed below are displayed during normal warm-up and
printing.
Other messages that may appear when the printer needs the operator's
attention are explained in
Message
Self test
Please wait
Ready
Processing
Sleeping
Cancelling data
Waiting
FormFeed Time Out
Interface Indicator
The interface indicator shows the interface that is currently used. It uses
the following abbreviations:
PAR
SER
OPT
---
Each interface has a timeout time of 30 seconds during which the other
interface should wait to receive a print job. Even a print job has been
complete on the interface, you should wait for this period until the other
Note
interface begins printing the job.
Chapter
The printer is self-testing after power-up.
The printer is warming up and is not ready. When
the printer is switched on for the first time after the
toner container is installed,
also appears.
The printer is ready to print.
The printer is receiving data, generating graphics,
reading a CompactFlash card/Microdrive, or
printing.
The printer is in Sleep mode. The printer wakes
from Sleep mode whenever a key on the operator
panel is pressed, the cover is opened or closed, or
data is received. The printer then warms up and
goes online. The time that the printer takes to enter
Sleep mode depends on the Sleep Timer setting.
Jobs inside the printer are being canceled. To cancel
a job, see the table on page 1-5.
The printer is waiting for the end-of-job command
before printing the last page. Pressing the
allows you to obtain the last page immediately.
The printer is printing the last page after a waiting
period.
INTERFACE
Standard bi-directional parallel interface
Serial interface (RS-232C)
Option network interface card
No interface is active.
1-2
4.
Meaning
(Adding toner)
GO key