Kyocera Mita FS-1800/N User Manual page 59

Changing Network Interface Parameters
This section applies to the printers having the option network card
installed. The FS-1800N/FS-3800N come standard with a network
interface card installed. For details concerning the network when using
Option
the FS-1800N/FS-3800N, refer to the supplied
To make your printer supports Netware, TCP/IP , and EtherTalk networks,
you will need to install the option network interface card in the printer and
make the proper settings as explained in this section.
You can also have a status page for the network interface card printed out
each time the printer is turned on.
1
MENU
2
3
ENTER
4
5
ENTER
Press the MENU key.
Press the or key repeatedly until Interface > appears. One
of the interface names shown below appears, indicating the current
interface.
Parallel (default)
Serial
Option
Press the ENTER key. A blinking question mark (?) appears.
Interface
? Parallel
Press the or key repeatedly until Option appears.
Interface
? Option
Press the ENTER key again.
1-45
Using the Operator Panel
Network Manual.