Using the Operator Panel
MENU
ENTER
ENTER
Changing Serial Interface Modes
You can set the baud rate, data bits, stop bits, parity, and protocol for the
serial interface.
1
Press the MENU key.
2
Press the
or
of the interface names shown below appears, indicating the current
interface.
Parallel (default)
Serial
Option (with the FS-1800N/FS-3800N or when a network interface
card is installed)
3
Press the ENTER key. A blinking question mark (?) appears.
Interface
? Parallel
If you want to abandon the interface selection procedure, press the
CANCEL key. The interface remains unchanged.
4
Press the
or
Interface
? Serial
5
Press the ENTER key again.
key repeatedly until Interface > appears. One
key repeatedly until Serial appears.
1-42