Kyocera Mita FS-1800/N User Manual page 127

Resetting the Remaining Toner Counter
If the toner container was replaced when Replace toner Clean
Printer was not displayed, reset the toner counter as follows so that an
accurate toner gauge measurement is indicated on the status page. Note
that if this operation is performed when the toner cartridge is not replaced,
the toner gauge measurement will not be indicated correctly.
If the type of the toner kit (TK-60/TK-60E) was changed, the toner ID must
also be changed. See
Also refer to the
replacing the toner container.
1
MENU
2
3
?
4
5
ENTER
6
ENTER
7
MENU
Setting the Toner ID
User's Manual
Press the MENU key.
Press the or key repeatedly until Life Counters > appears.
Life Counters
Press the > key.
Press the or key repeatedly until >New Toner Installed.
appears
>New Toner
Installed
Press the ENTER key. A question mark (?) appears.
>New Toner
Installed ?
Press the ENTER key. The toner counter is reset.
Press the MENU key. The message display returns to Ready.
1-113
Using the Operator Panel
on page 1-132.
supplied with the toner kit when
>