Maintenance Messages - Kyocera Mita FS-1800/N User Manual

3.3.2

Maintenance Messages

The following table lists maintenance messages that you can deal with by yourself. If Call service
person appears, turn off the printer, disconnect the power cord, and contact your Kyocera Mita dealer.
Message
Add paper (paper source)
Call service
personAn:0123456
Call service
personBn:0123456
Call service
personCn:0123456
Call service
personEn:0123456
Call service
person Fn
Check waste
toner bottle
Clean printer
Press GO
Duplexer
rear cover open
Face-down tray
paper full
!"
:Alarm buzzer sounds when an error occurs. Press the CANCEL key to stop the alarm buzzer.
The paper has run out. Supply paper according to the paper source displayed (paper
cassette, MP tray, or optional paper feeder).
Messages indicating the printer status (Ready, Please wait, Processing*,
Waiting, and FormFeed Time Out*) are displayed alternately.
* These messages will not appear if the number of copies is set to 2 or more.
Fuser error (n=0, 1, 2, ...)-Call a service person. The printer does not operate when a
code beginning with A is displayed. The total number of pages printed is also
indicated.
Option paper feeder's error (n=0, 1, 2, ...)-Call a service person. The printer does not
operate when a code beginning with B is displayed. The total number of pages printed
is also indicated.
Communication error with the option unit (n=0, 1, 2, ...)-Call a service person. The
printer does not operate when a message beginning with C is displayed. The total
number of pages printed is also indicated.
Mechanical error (n=0, 1, 2, ...)-Call a service person. The printer does not operate
when a code beginning with E is displayed. The total number of pages printed is also
indicated.
Controller error (n=0, 1, 2, ...)-Call a service person. The printer does not operate
when a code beginning with F is displayed.
The waste toner bottle is not installed. After installing the waste toner bottle, you
should be able to print. Replace the old waste toner bottle with the new one which is
included in the TK-60/TK-60E toner kit. The message will also be shown if the waste
toner bottle has become full. The waste toner bottle should be replaced when the
message display eventually shows Toner low TK-60. See
!"
Replacement on page 2-2.
Please clean the inside of the printer. See
This message will be displayed when replacing the toner container after the message
Replace toner TK-60 is displayed. After cleaning the inside of the printer, press
the GO key and the printer will be ready for printing.
If Auto Continue is set to On, printing will be automatically resumed after a preset
period of time.
Open the option duplexer rear cover, then close tightly.
The face-down output tray has become full (approx. 250 pages). You must remove all
printed pages from the face-down output tray. When the printer senses that the face-
down output tray is empty again, it will continues printing into the face-down output
!"
tray.
Corrective Action
2.3 Cleaning
3-7
Indicators and Messages
2.1 Toner Container
on page 2-9.
(Continued on next page)