Setting The Paper Weight; Setting The Duplex Path - Kyocera Mita Ecosys FS-6020 Operation Manual

Chapter 1 Using the Operator Panel

Setting the Paper Weight

You can set the paper thickness for your customized paper
type.
NOTE
The default setting is Normal for each customized paper type
(Custom 1 to 8). The printer is factory-set so as to provide the
optimal printing functions/quality in this setting, which you need
not change for ordinary custom paper.
1 Display the custom paper type (see
Paper Type
above) and press the
2 Press the or
Weight appears.
>>Paper Weight
Normal
3 Press the ENTER key. A blinking question mark (?)
appears.
>>Paper Weight
? Normal
4 Press the or
thickness. The display changes as shown below.
Normal (default)
Heavy (Thick)
Extra Heavy
Light (Thin)
5 When the desired paper thickness displayed, press
the ENTER key.
6 Press the MENU key. The message display returns to
Ready.
If the paper type is set to Custom and the option du-
plexer is installed on the printer, duplex printing
can be enabled and disabled. See
Path below.
1-20
Customizing
key.
key repeatedly until >>Paper
key to display the desired paper
Setting the Duplex

Setting the Duplex Path

NOTE
To use this function, the duplexer must be installed on the print-
er.
If the paper type is set to Custom, you can set whether or not
to enable duplex printing as follows. The default setting is
Enable.
1 Display the custom paper type (see
Paper Type on page 1-19
2 Press the or
Path appears.
>>Duplex Path
Enable
3 Press the ENTER key. A blinking question mark (?)
appears.
>>Duplex Path
? Enable
4 Select Enable or Disable using the
5 Press the ENTER key.
6 Press the MENU key. The message display returns to
Ready.
Customizing
) and press the
key repeatedly until >>Duplex
or
key.
key.