Print Density - Kyocera Mita FS-1800/N User Manual

>Print Density
MENU
?
ENTER
ENTER
MENU
Adjusting the Print Density
The print density can be adjusted in five steps: from 01 (light) to 05 (dark).
The factory setting is 03.
1
Press the MENU key.
2
Press the or
Print Quality
3
Press the > key.
4
Press the or
>Print Density
03
5
Press the ENTER key. A blinking question mark (?) appears.
>Print Density
? 03
6
Select the print density from five steps from 01 (light) to 05 (dark)
using the or
If you want to abandon the setting procedure, press the CANCEL
key.
7
Press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
key repeatedly until Print Quality > appears.
>
key repeatedly until >Print Density appears.
key.
1-75
Using the Operator Panel