Kyocera Mita FS-1800/N User Manual page 214

5
The Properties sheet is displayed for the selected COM port. Click on
the Port Settings tab and set the port properties.
6
After setting the properties, click OK button.
DOS
1
Enter the following commands:
C:\>MODE COM1:96,N,8,1,P
C:\>MODE LPT1:=COM1
2
To test the interface, enter the following:
CTRL P
C:\>DIR
CTRL P
The software settings made using the above procedures are temporary. On
most computers, permanent settings must be made with DIP switches.
If you want to use a different baud rate or change any of the other RS-232C
parameters, this can be accomplished from the printer's operator panel.
See Changing the Interface Parameters
C-11
RS-232C Cable Connection
on page 1-40.