Using the Operator Panel
?
ENTER
6
Press the > key. Each time the
changes as shown below.
>NetWare
On
>TCP/IP
On
>EtherTalk
Off
>Opt. StatusPage
On
7
The following example explains how to activate TCP/IP protocol to
connect the printer in the network. You can select Netware or
EtherTalk in a similar manner.
>TCP/IP
On
If TCP/IP is currently Off is displayed, select On using the
key. Press the ENTER key again.
>TCP/IP
? On
or
>
>
This is the network interface card
status page print menu. See page 1-48.
>
1-46
key is pressed, the display
>TCP/IP
On
or
>