Honda XR125LK Owner's Manual page 129

dummyhead dummyhead
CLUTCH/GEARSHIFT LINKAGE
INSTALLATION
Apply locking agent to the stopper arm bolt threads.
Install the return spring [1], washer [2], stopper arm [3]
and bolt [4], while holding the spring end to the groove
on the stopper arm.
Tighten the stopper arm bolt to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the dowel pins [1] into the shift drum holes.
Hold the stopper arm [2] using a screwdriver and install
the gearshift cam [3] by aligning its holes [4] with the
dowel pins.
Apply locking agent to the gearshift cam bolt threads.
Install the gearshift cam bolt [1] and tighten it.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Check the gearshift spindle [1] for wear or bend.
Check the spindle plate [2] for wear, damage or
deformation.
Check the return spring [3] for fatigue or damage.
Apply engine oil to the gearshift spindle journals.
Install the thrust washer [4] onto the gearshift spindle
and insert the spindle into the crankcase.
10-12
[1]
Hook
[4]
[3]
[1]
[4]
[1]
[3]
[4]
[2]
[3]
[2]
[1]
[2]