Honda XR125LK Owner's Manual page 167

dummyhead dummyhead
FRONT WHEEL/BRAKE/SUSPENSION/STEERING
Apply grease to the throttle cable contact point.
Install the throttle grip [1] to the handlebar.
Install the throttle housing [2].
Apply grease to the throttle cable end [3].
Connect the throttle cable to the throttle pipe.
Apply grease to the throttle cable guide [4].
Install the throttle cable guide into the throttle housing.
Install the throttle housing cover [5].
Align the slit of the throttle housing and cover with the
punch mark [6] on the handlebar.
Install the throttle housing cover screws [7], and tighten
the forward screw first, then the rear screw.
Install the master cylinder [1] and holder [2] with the
XR125LK/LEK:
"UP" mark [3] on the holder facing up.
Install the master cylinder holder bolts [4].
Align the end of the master cylinder with the punch
mark [5] on the handlebar, and tighten the upper bolt
first, then lower bolt.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the brake lever bracket [1] and holder [2] with the
XL125LK:
"UP" mark [3] on the holder facing up.
Install the holder bolts [4].
Align the end of the brake lever bracket with the punch
mark [5] on the handlebar, and tighten the upper bolt
first, then lower bolt.
Install the front visor [2] (page 2-4).
Connect the front brake light switch connectors [1].
XR125LK/LEK:
14-8
[4] [3]
[2] [1]
[5]
[4]
[2]
[3]
[1] [5]
[2]
[7]
[6]
[5]
[1] [2]
[3]
[4]
[1]