Gearshift Linkage - Honda XR125LK Owner's Manual

dummyhead dummyhead
CLUTCH/GEARSHIFT LINKAGE
Apply engine oil to the threads and seating surface of
the oil filter rotor lock nut [1], and then install it.
Install the gear holder between the primary drive and
driven gears, and tighten the oil filter rotor lock nut.
TOOLS:
[2] Gear holder
[3] Lock nut wrench
TORQUE: 64 N·m (6.5 kgf·m, 47 lbf·ft)
Install a new gasket [1] onto the oil filter rotor cover [2].
Install the oil filter rotor cover [1] and screws [2].
Tighten screws to the specified torque.
TORQUE: 4.0 N·m (0.4 kgf·m, 3.0 lbf·ft)
Install the oil pump driven gear [3].
Install the right crankcase cover (page 10-4).

GEARSHIFT LINKAGE

REMOVAL/INSPECTION
Remove the clutch (page 10-7).
Remove the bolt [1] and gearshift pedal [2].
When removing the
gearshift pedal,
Clean the left end of the gearshift spindle.
mark the pedal
position to ensure
the original position.
10-10
07724-0010200
07716-0020100
[3]
[1] [2]
[1]
[1]
[2]
[2]
[2]
[3]
[1]