Honda XR125LK Owner's Manual page 202

dummyhead dummyhead
NEEDLE BEARING REPLACEMENT
Remove the drive chain guard bolts, collars and drive
chain guard (page 15-14).
Remove the needle bearing [1] form the swingarm
using the special tools.
TOOL:
[2] Bearing remover set, 20 mm 07936-3710600
[3] Bearing remover weight
Bearing remover handle
Apply grease to a new needle bearing [1].
Press the needle bearings into the swingarm pivot so
Press the needle
that the needle bearing surface is lower 8.0 – 9.0 mm
bearing on the
(0.31 – 0.35 in) from the end of the swingarm using the
stamped side.
special tools and a hydraulic press.
TOOLS:
[2] Driver
[3] Attachment, 24 x 26 mm
[4] Pilot, 20 mm
INSTALLATION
Install the swingarm [1] onto the frame.
Install the swingarm pivot bolt [2] to the frame from the
left side.
Install and tighten the swingarm pivot nut [3] to the
specified torque.
TORQUE: 88 N·m (9.0 kgf·m, 65 lbf·ft)
Install the drive chain cover [1] on the swingarm.
Install the drive chain cover collars [2] and bolts [3],
then tighten the bolts.
REAR WHEEL/BRAKE/SUSPENSION
[3]
07741-0010201
07936-3710100
[2]
07749-0010000
07746-0010700
07746-0040500
[4]
[2]
8.0 – 9.0 mm
(0.31 – 0.35 in)
[3]
[1]
[1]
[1]
[2]/[3]
[1]
[2]/[3]
15-15