Honda XR125LK Owner's Manual page 95

dummyhead dummyhead
CYLINDER HEAD/VALVES
SYSTEM COMPONENTS
CYLINDER HEAD/VALVES
XR125LK/LEK shown:
16 N·m (1.6 kgf·m,
12 lbf·ft)
SERVICE INFORMATION
GENERAL
• This section covers service of the cylinder head, valves, rocker arms and camshaft.
• The camshaft can be serviced with the engine installed in the frame.
• The cylinder head service requires engine removal.
• Be careful not to damage the mating surfaces when removing the cylinder head cover and cylinder head. Do not strike the
cylinder head cover and cylinder head too hard during removal.
• When disassembling, mark and store the disassembled parts to ensure that they are reinstalled in their original locations.
• Clean all disassembled parts with cleaning solvent and dry them by blowing them off with compressed air before inspection.
• Camshaft and rocker arm lubricating oil is fed through oil passages in the cylinder head and camshaft holder. Clean the oil
passages before assembling cylinder head.
8-2
32 N·m (3.3 kgf·m, 24 lbf·ft)
10 N·m (1.0 kgf·m, 7 lbf·ft)
9.0 N·m (0.9 kgf·m, 6.6 lbf·ft)
4.0 N·m (0.4 kgf·m, 3.0 lbf·ft)