Honda XR125LK Owner's Manual page 192

dummyhead dummyhead
ASSEMBLY
Remove/install the following:
– Dust seal [1]
– Bolts [4]
– Distance collar [7]
• Replace the bearings and dust seal with new ones.
• Apply grease to the dust seal lip and bearing
cavities.
Refer to procedures for bearing replacement (page 15-6).
XR125LK/LEK shown:
[2]
32 N·m
(3.3 kgf·m, 24 lbf·ft)
[6] (6203UU)
WHEEL CENTER ADJUSTMENT
Adjust the hub position so that the distance from the left
end surface of the hub center to the side of rim is 18.0 ±
1.0 mm (0.71 ± 0.04 in) as shown.
Tighten the spokes in 2 or 3 progressive steps.
TOOL:
Spoke wrench, 5.8 x 6.1 mm
TORQUE: 3.7 N·m (0.4 kgf·m, 2.7 lbf·ft)
– Nuts [2]
– Driven sprocket [5]
– Left wheel bearing (6303U) [8]
[3]
[7]
07701-0020300
REAR WHEEL/BRAKE/SUSPENSION
– Washers [3]
– Right wheel bearing (6203UU) [6]
[8] (6303U)
[1]
XR125LK/LEK shown:
[5]
[4]
18.0 ± 1.0 mm
(0.71 ± 0.04 in)
15-5