General Information; Service Rules; Model Identification - Honda XR125LK Owner's Manual

dummyhead dummyhead

GENERAL INFORMATION

SERVICE RULES

GENERAL INFORMATION
1. Use genuine Honda or Honda-recommended parts and lubricants or their equivalents. Parts that do not meet Honda's design
specifications may cause damage to the motorcycle.
2. Use the special tools designed for this product to avoid damage and incorrect assembly.
3. Use only metric tools when servicing the motorcycle. Metric bolts, nuts and screws are not interchangeable with English
fasteners.
4. Install new gaskets, O-rings, cotter pins, and lock plates when reassembling.
5. When tightening bolts or nuts, begin with the larger diameter or inner bolt first. Then tighten to the specified torque diagonally in
incremental steps unless a particular sequence is specified.
6. Clean parts in cleaning solvent upon disassembly. Lubricate any sliding surfaces before reassembly.
7. After reassembly, check all parts for proper installation and operation.
8. Route all electrical wires as show in the Cable and Harness Routing (page 1-24).
9. Do not bend or twist control cables. Damaged control cables will not operate smoothly and may stick or bind.

MODEL IDENTIFICATION

This manual covers following types of XR125 and XL125 models; be sure to refer to the procedure for the appropriate version.
MODEL CODE
XR125LK DK
III LA
XR125LEK DK
III LA
CO
NZ
I LA
XL125LK II DK
XR125LEK shown:
1-2
WHEEL
SIZE
REGION
(Front/
Rear)
Common export 19/17 in
Latin America 19/17 in
Common export 19/17 in
Latin America 19/17 in
Colombia 19/17 in
New Zealand 19/17 in
Latin America 19/17 in
Common export 21/18 in
Electric Air cut-off
Kickstarter
starter
O –
O –
O O
O O
O O
O O
O O
O –
XL125LK shown:
Carburetor Sidestand
valve
heater switch
O O
O –
O O
O –
O –
O O
O O
– O
–
–
–
–
–
O
–
–