Transmitter List Management - Automatic Technology Easy Slider Installation Instructions Manual

TRANSMITTERS LIST MANAGEMENT
THE CONTROLLER PROVIDES A TRANSMITTER LISTING FACILITY WHICH ENABLES THE USER TO FIND A
TRANSMITTER LOCATION WITHIN ITS MEMORY. ONCE LOCATED, A STORED TRANSMITTER CAN BE
REPLACED, DELETED, EDITED OR, IF THE LOCATION IS EMPTY, A TRANSMITTER CAN CODED INTO IT.
STEP 1 ACCESSING THE LIST
METHOD 1. GO TO START OF LIST
The list be be accessed by selecting the "Code Transmitter"
MENU (as in STEP 1 of the BASIC CODE TRANSMITTER
PROCEDURE), followed by pressing NEXT. This will display
the list with transmitter number 1 shown.
Access The Code Transmitter MENU
MENU 1
Code Transmitter
Displaying The List starting at Transmitter #1
Press Tx'er
Button!
List with Transmitter #1 shown
# 1
1
PRESS
LIST>
PRESS
Location
Not used!
METHOD 2. GO TO A TRASMITTER'S LOCATION
WITHIN LIST
A particular transmitter's location within the list can be displayed
by selecting the "Code Transmitter" MENU (as in STEP 1 of
the BASIC CODE TRANSMITTER PROCEDURE), followed
by pressing anyone of the transmitter's buttons.
When the "Press Tx'er Again" message is displayed press NEXT
to display the transmitter's location within the list. NOTE
"VIEW>" will not be shown if the transmitter is not stored.
Access The Code Transmitter MENU
MENU 1
Code Transmitter
Press Transmitter Button
Press Tx'er
Button!
Display Transmitter's Location In List
Press Tx'er
Again!
List with Transmitter's location shown
#123 A & B SMITH
OSC PED LGT VAC
23
PRESS
LIST>
VIEW>
PRESS
3
PRESS