Trouble Shooting Guide - Automatic Technology Easy Slider Installation Instructions Manual

SYMPTOM
Gate will not operate.
Gate starts to close but automatically
reverses to open position.
Gate does not operate from transmitter.
*See note.
Gate will not close fully.
Gate will not open fully.
Auto close not working.
*Please Note: Some areas may be prone to excessive radio interference brought on by devices such as cordless telephones, wireless
stereo headphones and baby monitors. It is possible that these devices could cause a degree of interference such as to greatly reduce
the range of the transmitter. In such an instance please contact your ATA dealer for an alternative frequency replacement kit. As this is
not a warrantable situation but an environmental issue charges may apply for the changeover.

TROUBLE SHOOTING GUIDE

Mains power not switched on.
Gate is obstructed.
Gate is locked or motor jammed.
Gate tracks/hardware damaged.
Adverse weather conditions (wind or cold)
causing gate to stiffen and become tight in
the tracks.
Possible obstruction in the gateway.
Transmitter code not stored in memory.
Flat Battery.
Broken battery lead inside transmitter.
Gate limits positions need to be reset.
Gate limits positions need to be reset.
PE Beam or wiring faulty
PE Beam not aligned correctly.
PE Beam is obstructed.
Gate obstructed when closing.
Auto close time not set.
Auto close mode not set.
POSSIBLE CAUSE
29
REMEDY
Switch on mains power.
Remove obstruction.
Unlock door or remove jam.
Gate requires service/repair by qualified
technician.
Increase force margin setting and/or re-
initialise the door. See page 17.
Remove obstruction.
Code transmitter in to openers memory.
Refer page 21.
Replace battery - A23 Alkaline 12V.
Send transmitter to installer or ATA for
repair.
Reset limits positions. Page 11.
Reset limits positions. Page 11.
Repair PE Beam or replace wiring.
Re-align optics.
Remove obstruction from the path of PE.
Remove obstruction.
See page 17.
See page 17.