This chapter explains how to install the IES-1248-51.
2.1 General Installation Instructions
Before you begin, read all the safety warnings in
you follow them.
Perform the installation as follows:
1 Make sure the IES-1248-51 power switch is in the OFF position.
2 Install the hardware. See
3 Connect the frame ground. See
4 See
Chapter 3 on page 49
5 See
Chapter 4 on page 55
6 See
Chapter 5 on page 63
the IES-1248-51.
2.2 Installation Scenarios
The IES-1248-51 can be placed on a desktop or rack-mounted on a standard EIA rack. Use the
rubber feet in a desktop installation and the brackets in a rack-mounted installation.
For proper ventilation, allow at least 4 inches (10 cm) of clearance at the front and 3.4 inches
(8 cm) at the back of the IES-1248-51. This is especially important for enclosed rack
installations.
2.2.1 Desktop Installation Procedure
1 Make sure the IES-1248-51 is clean and dry.
2 Set the IES-1248-51 on a smooth, level surface strong enough to support the weight of
the IES-1248-51 and the connected cables. Make sure there is a power outlet nearby.
3 Make sure there is enough clearance around the IES-1248-51 to allow air circulation and
the attachment of cables and the power cord.
4 Remove the adhesive backing from the rubber feet.
Chapter 2 Hardware Installation
C
Hardware Installation
Section 2.2 on page
Section 2.3 on page
for instructions on making front panel connections.
for instructions on connecting the Telco-50 connectors.
for instructions on making power connections and turning on
IES-1248-51 User's Guide
H A P T E R
Safety Warnings
on page 5, and make sure
43.
46.
2
43