This chapter describes some of the ADSL commands that allow you to configure and monitor
the ADSL ports.
49.1 ADSL Commands
Use these commands to configure the ADSL ports. See
background information on ADSL.
49.1.1 ADSL Show Command
Syntax:
ras> adsl show [portlist]
where
[portlist]
This command shows the activation status, ADSL mode, maximum upstream and downstream
rate settings, profile and name of each ADSL port.
The following example displays information on ADSL port 5.
Figure 184 ADSL Show Command Example
ras> adsl show 5
port enable mode
---- ------ -------- ------------- ---------------- ----------------
5
-
49.1.2 ADSL Enable Command
Syntax:
ras> adsl enable <portlist>
Chapter 49 ADSL Commands
ADSL Commands
You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
up/downstream profile
auto
512/
2048 DEFVAL
C
H A P T E R
Chapter 16 on page 109
name
-
IES-1248-51 User's Guide
4 9
for
303