Spanning Tree Protocol Screen; Figure 83 Spanning Tree Protocol - ZyXEL Communications IES-1248-51 User Manual

Table 39 Spanning Tree Protocol Status (continued)
LABEL
Designated bridge
Designated port
Poll Interval(s)
Set Interval
Stop

24.3 Spanning Tree Protocol Screen

To open this screen, click Advanced Application, Spanning Tree Protocol, STP Config.

Figure 83 Spanning Tree Protocol

The following table describes the labels in this screen.
Table 40 Spanning Tree Protocol
LABEL
STP Status
Active
Chapter 24 Spanning Tree Protocol
DESCRIPTION
This is the unique identifier for the bridge that has the lowest path cost to reach
the root bridge, consisting of bridge priority plus MAC address.
This is the port on the designated bridge that has the lowest path cost to reach
the root bridge, consisting of bridge priority.
The text box displays how often (in seconds) this screen refreshes. You may
change the refresh interval by typing a new number in the text box and then
clicking Set Interval.
Click Stop to halt STP statistic polling.
DESCRIPTION
Click STP Status to display the IES-1248-51's STP status (see
page 167).
Select this check box to turn on RSTP.
Note: It is recommended that you only use STP when you use the
IES-1248-51 in standalone mode with a network topology
that has loops.
IES-1248-51 User's Guide
Section 24.2 on
169