Alarm Port Set Command; Figure 125 Alarm Port Show Command Example - ZyXEL Communications IES-1248-51 User Manual

The following example displays the port alarm thresholds for all ports. "ifindex" identifies the
interface.

Figure 125 Alarm Port Show Command Example

ras> alarm port show
Press any key to continue, 'e' to exit, 'n' for nopause
no
----- ----------
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
Press any key to continue, 'e' to exit, 'n' for nopause

40.5 Alarm Port Set Command

Syntax:
ras> alarm port set <all|enet1|enet2|port> <severity>
where
<all|enet1|enet
2|port>
This command sets the alarm severity threshold for recording alarms on an individual port(s).
The system reports an alarm on a port if the alarm has a severity equal to or higher than the
port's threshold.
Chapter 40 Alarm Commands
ifindex severity
-----------
01 minor
02 minor
03 minor
04 minor
05 minor
06 minor
07 minor
08 minor
09 minor
10 minor
11 minor
12 minor
13 minor
14 minor
15 minor
16 minor
17 minor
18 minor
19 minor
20 minor
Ports on the IES-1248-51.
=
IES-1248-51 User's Guide
251